A gui to display the output of fingertip/skin tactile sensors.
Collaboration diagram for iCubSkinGui:
A gui to display the output of fingertip/skin tactile sensors.
Description
The application is used to graphically display the output of the iCub fingertip/skin tactile sensors. This application can be used in two different modalities, CAN mode and YARP mode. If used in CAN mode, the application reads sensor data directly from the CAN bus.
If used in "YARP" mode,the application requires a yarp port connection to the iCubInterface output.
Libraries
YARP libraries.
Parameters
Usage:
iCubSkinGui <–from filename.ini> <–useCan>
You can use the –from parameter (optional) to specify a .ini configuration file.
If no configuration file is specified, then $ICUB_ROOT/app/iCubSkinDemo/lefthand.ini is used.
You can use the –useCan parameter (optional) to ask the application to read sensor data directly from the CAN bus (the CAN parameters must be specified in the configuration file). Otherwise the application opens an input yarp ports and waits for a yarp connection with a stream of sensory data.
Ports Accessed
None
Ports Created
This application can be used in two different modalities, CAN mode and YARP mode.
If used in CAN mode, this application does not create any input port, and the data are directly obtained from the CAN bus.
If used in YARP mode, this application creates the port:
/skinGui/<robotPart>:i
where <robotPart> correspondes to the value of the parameter robotPart contained in the .ini configuration file.
For example, if $ICUB_ROOT/app/iCubSkinDemo/lefthand.ini is used, the module creates the port /skinGui/left_hand:i. The port must be afterwards connected to the output port corresponding to the skin output in iCubInterface.
Examples:
yarp connect /icub/skin/lefthand /skinGui/left_hand:i
yarp connect /icub/skin/righthand /skinGui/right_hand:i
Input Data Files
No input files are required by this application.
Output Data Files
No output files are generated by this application.
Configuration Files
The application uses configuration files (e.g. lefthand.ini) located in $ICUB_ROOT/app/iCubSkinDemo. You can select the configuration file used by the application using:
–from <filename>.
If the –from parameter is not specified, $ICUB_ROOT/app/iCubSkinDemo/lefthand.ini is used as default.
Tested OS
Linux and Windows.
Example Instantiation of the Module
iCubSkinGui
iCubSkinGui –from lefthand.ini
iCubSkinGui –from righthand.ini
iCubSkinGui –from lefthand.ini –useCan
iCubSkinGui –from righthand.ini –useCan
Copyright (C) 2009 RobotCub Consortium
CopyPolicy: Released under the terms of the GNU GPL v2.0.
This file can be edited at /src/gui/iCubSkinGui/src/main.cpp.
